How to install the spring brake air chamber

Instructions for use of the spring brake air chamber:
For driving safety, preventing failure and ensuring the normal service life of the double-diaphragm spring brake chamber, the double-diaphragm spring brake chamber should be used, installed and maintained correctly as required.
1. After the brake air chamber is installed on the rear axle, screw the release brake bolt into the bottom, turn the loosened brake release bolt by 90°, take it out, put it on the special position of the middle casing and lock it; during the operation It is best to put the handle of the hand brake valve in the release brake position, that is, fill the spring brake chamber with air pressure, so that it is more labor-saving to turn the release brake bolt.
2. It is very dangerous to disassemble the spring brake chamber, and it should not be disassembled blindly to prevent the large spring from jumping out and hurting people. If it must be disassembled, it should be carried out under the guidance of industry insiders.
3. Mechanical locking, if the air compressor is damaged and the spring brake cylinder cannot be inflated, use a wrench to screw the locking bolt C to the release braking position, and then drag the car back for repair.
4. When installing the product, install the air pipe according to the connection method in the third piping diagram of this manual.
5. It should be ensured that the two bolts connecting the brake air chamber and the brake cam bracket are fastened and reliable.
chinafuao.net